Drive Section; Detaching And Refitting The Main Motor; Detaching And Refitting The Drive Unit - Kyocera FS-6025MFP/B Service Manual

1-5-8 Drive section

(1) Detaching and refitting the main motor

Procedure
1. Remove the rear cover.
(See page 1-5-5)
2. Remove the connector from the engine
PWB.
3. Remove the wire from the hook.
4. Remove four screws and then remove
the main motor.

(2) Detaching and refitting the drive unit

Procedure
1. Remove the rear cover.
(See page 1-5-5)
2. Remove the connector from the engine
PWB.
3. Remove five screws and then remove
the drive unit.
4. Check or replace the drive unit and refit
all the removed parts.
Connector
Screws
Screws
Main motor
Drive unit
Screws
Screw
Screw
Screw
1-5-22
Engin PWB
Socket(YC16)
Hook
Wire
Connector
Figure 1-5-35
Engin PWB
Socket(YC1)
Connector
Figure 1-5-36
2K3/2L3
Connector