Kyocera TASKalfa 3050ci Service Manual page 428

11. Release two wire saddles.
12. Remove three connector.
13. Remove five screws and then remove
the drum drive unit MCY.
*: Do not have a shaft part alone when you
carry drum drive unit MCY. (Have the
housing.)
*: Put support on the tip of the shaft so that
the shaft may become the horizontal
when you put drum drive unit CMY on the
table etc.
14. Check or replace the drum drive unit K
and the drum drive unit MCY and refit
all the removed parts.
Connector
Wire saddle
Connector
Wire saddle
Figure 1-5-117
(Shaft portion)
Screw
Screw
Figure 1-5-118
1-5-72
2LK/2LN/2LM/2LC
Connector
(Shaft portion)
Drum drive
unit MCY
(housing portion)
Screw
Screws