Kyocera TASKalfa 3050ci Service Manual page 264

Code
7300 CF eject sensor non arrival
jam
7310 CF eject sensor stay jam
7400 CF side registration sensor 2
non arrival jam
7500 CF side registration sensor 1
non arrival jam
7600 CF staple operation error
7720 CF paper sensor remaining
jam
7800 MB eject sensor non arrival
jam
7810 MB eject sensor stay jam
7820 MB eject sensor remaining
jam
7950 Paper interval error jam
7951
9000 No original feed
9001 DP original conveying jam
9002 DP sensor stay jam
9004 DP switchback jam 2
9005 No original feed 2
9008 No original feed 3
DP original conveying jam 2
9009
*: Refer to figure 1-4-1 for paper misfeed indication (see page 1-4-1).
Contents
CF eject sensor (CFES) is not turned on within
specified time since three fold operation starts.
During three fold operation, CF eject sensor
(CFES) is not turned off within specified time of its
turning on.
CF side registration sensor 2 (CFSRS2) is not
turned on within specified time after driving the
CF side registration motor 2 (CFSRM2).
CF side registration sensor 1 (CFSRS1) is not
turned on within specified time after driving the
CF side registration motor 1 (CFSRM1).
CF staple sensor (CFSTS) is not turned on within
specified time after driving the CF staple motor
(CFSTM).
CF paper sensor (CFPS) does turned on when
the power is turned on or cover close.
MB eject sensor (MBES) is not turned on even if
a specified time has elapsed after the machine
eject signal was received.
MB eject sensor (MBES) is not turned off within
specified time of its turning on.
MB eject sensor (MBES) does turned on when
the power is turned on or cover close.
An illegal inter-page or inter-copy interval has
occurred (4000-sheet finisher).
An illegal inter-page or inter-copy interval has
occurred (1000-sheet finisher).
DP feed sensor (DPFS) does not turn on within
specified time during the first sheet feeding (Retry
5 times).
DP timing sensor (DPTS) turns off within the
specified time since the sensor turns on.
Sensor in the conveying system is on since origi-
nal feeding starts.
DP registration sensor (DPRS) is not turned on
within specified time since original switchback
operation starts.
DP lift sensor 1 (DPLS1) does not turn on within
specified time of the lift plate rising.
DP CIS sensor (DPCS) does not turn on within
specified time of the paper feed starting.
Next feed original became the stand-by states of
paper feed while reading the image.
Conditions
1-4-24
2LK/2LN/2LM/2LC
Jam
location*
K
K
K
K
K
K
K
K
K
K
K
H
H
H
H
H
H
H