Fault Messages Of The Sensor-Switch-Box - Roland R1000 Series Manual

Fault messages, causes and remedies
9.1

Fault messages of the Sensor-Switch-Box

If the Sensor-Switch-Box was configured though none is attached to the system, then the system
emits a fault message. In order to reconfigure the equipment to the correct adjustment "no Sensor
Switch Box", the unit must be switched off and on.
The following message is displayed:
no switchbox
or defective
Fig. 106: System does not recognize a Sensor-Switch-Box
After pressing the MENU key the following message is displayed:
UDK20+switchbox?
yes
Fig. 107: Selection, if the Sensor-Switch-Box is to be operated
Adjustment for operating the Sensor Switch Box:
• yes: The equipment should continue operating with a Sensor Switch Box.
The fault is cleared. If the fault condition is not eliminated, then the fault message appears
again.
• no = CLR Param.: The equipment has to be reconfigured to operate without a Sensor Switch
Box. All program parameters are deleted.
The arrow keys allow the change between "yes" and "no". Confirm the selection with the ENTER
key.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
130
Double Sheet Detector R1000 series UDK20
with integrated fieldbus interface
Attention The deletion of the programs parameter cannot be undone.
Manual
B0048191 / Rev. 1.5