Operation - Roland R1000 Series Manual

Start-up
7.2

Operation

After applying power to the system, the version number and the bus system message are briefly
displayed. Afterwards the system switches into that measurement menu which was active before
the unit was switched off.
Fig. 40: Frontal view of the R1000 with enlarged display detail
LED functions (symbols above the keys)
< ON, if the measured value reaches (or falls short of) the lower limit value.
Norm ON, if the measured value is within the lower and upper limit values.
ON, if the measured value reaches (or exceeds) the upper limit value.
>
Enable - blinks, if a fault is present
- ON, if the equipment is in measurement mode
- OFF, during parameter programming with the keyboard
Key functions (symbols below the keys)
▲
 Changes the parameters (forward)
▼
 Changes the parameters (backwards)
Enter Selects a parameter for changing and confirming the change
Menu Activates the menu level, for deleting a fault message and exiting the menu level.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
104
Double Sheet Detector R1000 series UDK20
with integrated fieldbus interface
Note Units with CanOpen bus module require approx. 30 seconds to reach
the operational status after applying power to the system.
Note The system is factory adjusted for "single measurement". Therefore the
system functions only if the signal "measurement start" is activated via
the fieldbus. The modification of the configuration is described in the
following sections.
1-1 FE=1.00mm -on
0.80 <S1=1.02> 1.20
Profibus DP xxx
Online / closed 1
Manual
3 4 5
1-1 FE=1.00mm
0.80 <S1=1.02> 1.20
8
Profibus DP
10
Online / closed
12
13
1 LED functions 8 Lower limit value
2 Pushbutton functions 9 Upper limit value
3 Program number 10 Bus type
4 Selected sensor 11 Bus baud rate or MAC-ID
5 Type of material 12 Fieldbus status
6 Nominal thickness 13 Sensor number with selected value
7 Measurement status 14 Bus address
B0048191 / Rev. 1.5
6 7
-on
9
xxx
11
1
14