Mitsubishi Electric MR-J2S-A Instruction Manual page 31

1. FUNCTIONS AND CONFIGURATION
(3) MR-J2S-500A
MODE UP DOWN
POINT
The servo amplifier is shown without the front cover. For removal of the
front cover, refer to section 1.7.2.
Battery connector (CON1)
Used to connect the battery for absolute position data
backup.
Battery holder
Contains the battery for absolute position data backup.
Display
The 5-digit, seven-segment LED shows the servo status
and alarm number.
Operation section
SET
Used to perform status display, diagnostic, alarm and
parameter setting operations.
MODE
Fixed part
(4 places)
I/O signal connector (CN1A)
Used to connect digital I/O signals.
I/O signal connector (CN1B)
Used to connect digital I/O signals.
Communication connector (CN3)
Used to connect a command device (RS-422/RS-232C)
and output analog monitor data.
Encoder connector (CN2)
Used to connect the servo motor encoder.
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Control circuit terminal block (TE2)
Used to connect the control circuit power supply and
regenerative option.
Main circuit terminal block (TE1)
Used to connect the input power supply and servo
motor.
Rating plate
Cooling fan
Protective earth (PE) terminal (
Ground terminal.
1 - 12
WWW.NNC.IR
Name/Application
UP DOWN SET
Used to set data.
Used to change the
display or data in each
mode.
Used to change the
mode.
)
Reference
Section 15.3
Section 15.3
Chpater 6
Chapter 6
Section 3.3
Section 3.3
Section 3.3
Section 13.1.5
Chapter 14
Section 3.3
Section 13.1.5
Section 3.7
Section 11.1
Section 13.1.1
Section 3.7
Section 11.1
Section 1.5
Section 3.10
Section 11.1