Procedure
1. Remove seven screws.
2. Pull the rear cover upwards and then
release three hooks.
3. Remove the rear cover.
4. Cut the aperture part (left side) of the
rear cover using nippers etc.
5. Release the wire saddle and the guide
hook and then remove the connector
from the DP relay PWB.
6. Remove the screw and remove the DP
connector mounting plate.
Rear cover
Screw
Screw
Screw
Screws
Screw
Hooks
Screw
Connector
DP relay PWB
Guide Hook
1-2-63
Aperture part
Hook
Figure 1-2-88
Wire saddle
Screw
DP connector
mounting plate
Figure 1-2-89
2NL/2P8