U610 Setting System 1 - Kyocera TASKalfa 3510i Service Manual

Item No.
U610 Setting system 1
Description
Makes settings for fax reception regarding the sizes of the fax paper and received images and
automatic printing of the protocol list.
Method
1. Press the start key.
2. Select the item to be set.
Cut Line(100%)
Cut Line(Auto)
Cut Line(A4)
Setting:[Cut Line(100%)]
Sets the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when recording the data at 100% magnification. If the number of excess lines is
below the setting, those lines are ignored. If over the setting, they are recorded on the next page.
1. Change the setting using the +/- keys or numeric keys.
Number of lines to be ignored when receiving at 100%
* : Increase the setting if a blank second page is output, and decrease it if the received
image does not include the entire transmitted data.
2. Press the start key. The value is set.
Setting:[Cut Line(Auto)]
Sets the maximum number of lines to be ignored if the received data volume exceeds the record-
ing capacity when the data is recorded in the auto reduction mode. If the number of excess lines
is below the setting, those lines are ignored. If over the setting, the entire data on a page is fur-
ther reduced so that it can be recorded on the same page.
1. Change the setting using the +/- keys or numeric keys.
Number of lines to be ignored when receiving in the auto
reduction mode
* : Increase the setting if a page received in the reduction mode is over-reduced and too
much trailing edge margin is left. Decrease it if the received image does not include all
transmitted data.
2. Press the start key. The value is set.
Display
Sets the number of lines to be ignored when receiving a fax at
100% magnification.
Sets the number of lines to be ignored when receiving a fax in
the auto reduction mode.
Sets the number of lines to be ignored when receiving a fax
(A4R/LetterR) in the auto reduction mode.
Description
Description
Description
Description
1-3-139
Setting Initial
range setting
0 to 22 3
Setting Initial
range setting
0 to 22 0
2NL/2P8