Kyocera TASKalfa 3510i Service Manual page 467

12. Lift sensor 1 (LS1)................................. Detects activation of upper limit of the bottom plate in the cassette
13. Lift sensor 2 (LS2)................................. Detects activation of upper limit of the bottom plate in the cassette
14. Feed sensor 1 (FS1) ............................. Detects a paper misfeed in the vertical conveying section.
15. Feed sensor 2 (FS2) ............................. Detects a paper misfeed in the vertical conveying section.
16. Registration sensor (RS)....................... Controls the secondary paper feed start timing.
17. Eject sensor (ES) .................................. Detects a paper misfeed in the fuser or eject section.
18. Duplex sensor (DUS) ............................ Detects a paper jam in the duplex section.
19. Paper full sensor (PFS)......................... Detects the paper full in the inner tray.
20. Job paper full sensor (JPFS) ................ Detects the paper full in the job separator tray.
21. Job eject papersensor (JEPS) .............. Detects the presence of paper in the job separator.
22. Paper size width switch 1 (PWSW1)..... Detects the width of paper in the cassette 1.
23. Paper size width switch 2 (PWSW2)..... Detects the width of paper in the cassette 2.
24. Paper size length switch 1 (PLSW1) .... Detects the length of paper in the cassette 1.
25. Paper size length switch 2 (PLSW2) .... Detects the length of paper in the cassette 2.
26. Toner container lock sensor (TCLS) ..... Detects the lock of toner in the toner container.
27. Main power switch (MSW) .................... Turns ON/OFF the AC power source.
28. Cassette heater switch (CHSW) ........... Turns ON/OFF the cassette heater power source.
29. Temperature sensor (TEMS)................. Detects the temperature and absolute humidity outside the
30. Toner sensor (TS) ................................. Detects the amount of toner remaining in the toner container.
31. Waste toner sensor (WTS).................... Detects when the waste toner box is full.
32. Fuser thermistor 1 (FTH1) .................... Detects the heat roller temperature. (contact / edge)
33. Fuser thermistor 2 (FTH2) .................... Detects the heat roller temperature. (noncontact / center)
34. Toner container switch (TCSW) ............ Detects the presence of toner container.
35. MP tray switch (MPTSW)...................... Detects the position of the MP sub tray.
36. MP paper width switch (MPPWSW)...... Detects the width of paper in the MP tray.
37. MP paper length switch (MPPLSW)...... Detects the length of paper in the MP tray.
1.
2.
machine.
2-2-4
2NL/2P8-B