1030 Pf Lift Motor 1 Error (Paper Feeder) - Kyocera TASKalfa 3510i Service Manual

Code Contents
1030 PF lift motor 1 error
(paper feeder)
After cassette 3 is inserted,
PF lift sensor 1 does not turn
on within 12 s. This error is
detected 5 times successively.
During driving the motor, the
lift overcurrent protective
monitor signal is detected for
1 s or more 5 times succes-
sively. However, the first 1 s
after motor is turned on is
excluded from detection.
Related parts
Cassette lift base
Check that the cassette base can be
elevating
manipulated smoothly, if not, repair or
mechanism replace.
PF Lift motor 1
PF Lift sensor 1
PF main PWB
Replace the PF main PWB (Refer to the
service manual for the paper feeder).
1-4-21
Check procedures/
corrective measures
1. Check that the cassette base has been
ascended.
2. Check the drive gear can rotate or they
are not unusually loaded and, if
necessary, replace.
3. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
PF Lift motor 1 and PF main PWB
4. If the wiring is disconnected, shorted or
grounded, replace the wiring.
5. Replace the PF lift motor 1.
1. Check that the sensor is correctly
positioned.
2. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
PF Lift sensor 1 and PF main PWB
3. If the wiring is disconnected, shorted or
grounded, replace the wiring.
4. Replace the PF lift sensor 1.
2NL/2P8-8