Preparation For Disassembly; Remove Flywheel Or Drive Plate; Remove Rear End Plate; Remove Rh And Lh Engine Mounting Brackets - Toyota 22R-E Service Manual

ENGINE – ENGINE MECHANICAL

PREPARATION FOR DISASSEMBLY

(See Components)

1. REMOVE FLYWHEEL OR DRIVE PLATE

(a) Remove the eight bolts.
(b) (M/T)
Remove the flywheel.
(c) (A/T)
Remove the rear plate, drive plate and front spacer.

2. REMOVE REAR END PLATE

Remove the bolt and rear end plate.
3. INSTALL ENGINE STAND FOR DISASSEMBLY
4. REMOVE RH AND LH ENGINE MOUNTING
BRACKETS
Remove the four bolts and mounting bracket. Remove
the two mounting brackets.
5. REMOVE ENGINE COOLANT DRAIN PLUGS
6. REMOVE TIMING BELT
(See pages EG2–33
7. REMOVE CYLINDER HEADS
(See pages EG2–53
to 38)
to60)
EG2–95