Reconnect High–Tension Cords To Sparkplugs; Generator Drive Belt Inspection - Toyota 22R-E Service Manual

ENGINE – ENGINE MECHANICAL
6. INSTALL SPARK PLUGS
Using a 16 mm plug wrench, install the six spark
plugs.
Torque: 18 N–m (18o kgf–cm, 13 ft–lbf)
7. RECONNECT HIGH–TENSION CORDS TO SPARK
PLUGS

GENERATOR DRIVE BELT INSPECTION

INSPECT DRIVE BELTS
(a) Visually check the belt for excessive wear, frayed
cords etc.
If necessary, replace the drive belt.
HINT: Cranks on the rib side of a belt are considered
acceptable. If the belt has chunks missing from the
ribs, it should be replaced.
(b) Using a belt tension gauge, measure the belt tension.
Belt tension gauge:
BTG–20 (95506–00020) for nippondenso
No. BT–33–73F for borroughs
Drive belt tension:
New belt
160 20 lbf
Used belt
100 20 lbf
If necessary, adjust the belt tension.
HINT:
"New belt" refers to a belt which has been used
less than 5 minutes on a running engine.
"Used belt" refers to a belt which has been used
on a running engine for 5 minutes or more.
After installing the belt, check that it fits properly
in the ribbed grooves.
Check by hand to confirm that the belt has not
slipped out of the groove on the bottom of the
pulley.
After installing a new belt, run the engine for
about 5 minutes and recheck the belt tension.
EG2–17