ENGINE
–
ENGINE MECHANICAL
(q) Connect the vacuum and fuel hoses to the pressure
regulator.
(r) Connect the charcoal canister vacuum hose to the
throttle body.
(s) Connect the throttle position sensor connector.
25.INSTALL TIMING BELT
See steps 2, 7 to 16, 22 and 24 on pages
48)
26. INSTALL DISTRIBUTOR
(See steps 1 and 2 on pages
27. CONNECT HIGH–TENSION CORDS TO SPARK
PLUGS
28. INSTALL FRONT EXHAUST PIPE
(a) Connect the exhaust pipe to the LH exhaust manifold
with new gasket and three new nuts.
Torque: 62 N–m (630 kgf–cm, 46 ft–Ibf)
(b) Connect the exhaust pipe to the catalytic converter
with new gasket and the two bolts.
Torque: 39 N–m (400 kgf–cm, 29 ft–Ibf)
(c) Install the pipe bracket to the transmission with the
two bolts.
(d) Install the pipe bracket to the exhaust pipe with the
pipe clamp.
(e) Connect the oxygen sensor connector–.
29. CONNECT FUEL INLET AND OUTLET HOSES
30. CONNECT HEATER HOSES
EG2–41
to
IG–25
and 26)
EG2–87