Connect Cables, Hoses, Connectors, Strap And Wires - Toyota 22R-E Service Manual

EG2–88
ENGINE – ENGINE MECHANICAL
31. CONNECT CABLES, HOSES, CONNECTORS, STRAP
AND WIRES
(a) Connect the following cables:
Accelerator cable
(A/T only)
Throttle cable
(w/ Cruise Control System)
Cruise control cable
(b) Connect the following hoses:
PS air hoses to gas filter and air pipe
Brake booster hose
(w/ Cruise Control System)
Cruise control vacuum hose
Charcoal canister hose from canister
VSV vacuum hoses
(c) Connect the following strap, wires and connectors:
Ground strap to LH fender apron
Generator connector and wire
Igniter connector
Oil pressure sender gauge connector
Ground strap to engine rear side
ECM connectors
VSV connectors
A/C compressor connector
(M/T only)
Starter relay connector
Solenoid resister connector
Data link connector 1
(w/ ADD)
ADD switch connector
32. INSTALL GENERATOR DRIVE BELT
33. INSTALL COOLING FAN
Install the cooling fan with the four nuts.
Torque: 5.4 N–m (55 kgf–cm, 48 in.–Ibf)
34. INSTALL A/C DRIVE BELT
35. INSTALL PS PUMP
36. INSTALL PS PUMP PULLEY AND DRIVE BELT