ENGINE
–
ENGINE MECHANICAL
(c) Align the notch on the piston with the mark on the rod
and push the piston pin in with your thumb.
(d) Install a new snap ring on the other side of the pin.
2. PLACE RINGS ON PISTON
(a) Install the oil ring expander and two side rails by hand.
(b) Using a ring expander, install the two compression
rings with the code marks facing upward.
(c) Position the piston rings so that the ring end gaps are
as shown.
NOTICE: Do not align the end gaps.
3. INSTALL BEARINGS
(a) Install the bearing in the connecting rod and rod cap.
(b) Lubricate the face of the bearings with engine oil.
NOTICE: Install the bearings with the oil hole in the
connecting rod.
EG1–67