Remove Oil Cooler (2Wd); Oil Cooler Inspection; Oil Cooler Installation - Toyota 22R-E Service Manual

ENGINE – LUBRICATION SYSTEM
3. REMOVE OIL COOLER
(2WD)
Remove the two bolts, union bolt, relief valve, gaskets
and oil cooler.
(4W D)
Remove the bolt, relief valve, gaskets and oil cooler.

OIL COOLER INSPECTION

INSPECT OIL COOLER
Check the oil cooler for damage or clogging.
If necessary, replace the oil cooler.

OIL COOLER INSTALLATION

(See components)
1. INSTALL OIL COOLER
(a) Replace the O–ring(s) with a new part.
(b) (2WD)
Install the oil cooler with the relief valve, union
bolt and three new gaskets.
Torque: 59 N–m (600 kgf–cm, 43 ft–lbf)
Install and torque the two bolts.
Torque: 39 N–m (400 kgf–cm, 29 ft–lbf)
(4WD)
Install the oil cooler with the relief valve and two
new gaskets.
Torque: 59 N–m (600 kgf–cm, 43 ft–lbf)
Install and torque the two bolts.
Torque: 39 N–m (400 kgf–cm, 29 ft–lbf)
EG2–289