Install Cold Start Injector Tube; Check For Fuel Leakage - Toyota 22R-E Service Manual

ENGINE – MFI SYSTEM

2. INSTALL COLD START INJECTOR TUBE

Using new gaskets, connect the cold start injector
tube with the union bolts.
Torque: 15 N–m (150 kgf–cm, 11 ft–lbf)
3. CONNECT COLD START INJECTOR CONNECTOR
4. CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY

5. CHECK FOR FUEL LEAKAGE

(a) With the ignition switch ON, use SST to connect
terminals FP and +B of the DLC1.
SST 09843–18020
(b) Check for fuel leakage.
(c) Remove SST from the DLC1.
EG2–211