Connect Following Hoses; Connect Following Wires And Connectors; Install Ps Pump And Belt - Toyota 22R-E Service Manual

EG1–74
ENGINE – ENGINE MECHANICAL
(b) (w/Cruise control)
Cruise control cable
(c) Accelerator cable

26. CONNECT FOLLOWING HOSES:

(a) Charcoal canister hose to canister
(b) (w/Cruise control)
Cruise control vacuum hose
(c) Brake booster hose
(d) PS air hoses to gas filter and air pipe
27. CONNECT FOLLOWING WIRES AND CONNEC–
TORS:
(a) (with A/C)
A/C compressor connector
(b) Check connector
(c) (M/T)
Starter relay connectors
(d) ECM connectors
(e) Ground strap to engine rear side
(f) Distributor wire
(g) High–tension cords
(h) Generator wires
(i) Igniter connector
(j) Generator connector and wire
(k) Ground strap to LH fender apron
28. INSTALL FAN PULLEY, BELT GUIDE, FLUID COU–
PLING AND GENERATOR DRIVE BELT
(See step 9 on page EG1–44)
29. (with A/C)
INSTALL A/C BELT
(see step 2 on page MA–6)

30. INSTALL PS PUMP AND BELT

(a) Place the PS drive belt onto each pulley.
(b) Stretch the belt tight and tighten the nuts.
(c) Torque the PS pump pulley lock nut.
Torque: 43 N–m (440 kgf–cm, 32 ft–lbf)
(d) adjust the belt tension.
(See step 2 on page MA–6)
31. INSTALL RADIATOR
32. INSTALL AIR CLEANER CASE AND INTAKE AIR
CONNECTOR
33. FILL WITH ENGINE OIL
(See step 3 on page EG1–236)
34. FILL WITH COOLANT
(See step 3 on page EG1–225)
35. INSTALL ENGINE UNDER COVER
36. INSTALL BATTERY
37. INSTALL HOOD
38. START ENGINE
Warm up the engine and inspect for leaks.