Connect Throttle Cable (A/T); Connect Exhaust Pipe To Exhaust Manifold; Start Engine; Road Test - Toyota 22R-E Service Manual

EG1–38
ENGINE – ENGINE MECHANICAL
(h) EGR vacuum modulator hose
(i) EVAP hose
(j) (with A/C)
VSV hoses
(k) (w/PS)
Air control valve hoses
(l) Brake booster hose
(m) No. 1 and No. 2 PCV hoses
11. CONNECT GROUND STRAP TO ENGINE REAR SIDE
12. (A/T)
CONNECT THROTTLE CABLE
Connect the throttle cable to the clamp and bracket.
13. CONNECT ACCELERATOR CABLE
14. CONNECT HEATER WATER INLET HOSE TO
HEATER WATER INLET PIPE
15. INSTALL RADIATOR INLET HOSE
16. INSTALL SPARK PLUGS AND DISTRIBUTOR
(See pages IG–6, 9)
17. INSTALL OIL DIPSTICK
18. CONNECT EXHAUST PIPE TO EXHAUST MANI–
FOLD
(a) Install the new gaskets, and connect the exhaust pipe
to the exhaust manifold with the three nuts.
(b) Install the exhaust pipe clamp.
19. INSTALL INTAKE AIR CONNECTOR
20. FILL WITH ENGINE OIL
(See step 3 on page EG1–236)
21. FILL WITH COOLANT
(See step 3 on page EG1–225)
22. CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY

23. START ENGINE

Warm up the engine and inspect for leaks.
24. PERFORM ENGINE ADJUSTMENT
(See page EG1–10)
25. RECHECK COOLANT AND ENGINE OIL LEVEL

26. ROAD TEST

Road test the vehicle.
27. RECHECK COOLANT AND ENGINE OIL LEVEL