EG2–132
ENGINE
–
ENGINE MECHANICAL
19. CONNECT HEATER HOSES
20. CONNECT FUEL INLET AND OUTLET HOSES
21. CONNECT STRAP, WIRES, CONNECTORS,
HOSES AND CABLES
(a) Connect the following cables:
Accelerator cable
(A/T only)
Throttle cable
(w/ Cruise Control System)
Cruise control cable
(b) Connect the following hoses:
PS air hoses to gas filter and air pipe
Brake booster hose
(w/ Cruise Control System)
Cruise control vacuum hose
Charcoal canister hose to canister
VSV vacuum hoses
(c) Connect the following strap, wires and connectors:
Ground strap to LH fender apron
Generator connector and wire
Igniter connector
Oil pressure sender gauge connector
Ground strap to engine rear side
ECM connectors
VSV connectors
A/C compressor connector
(M/T only)
Starter relay connector
Solenoid resister connector
Data link connector 1
(w/ ADD)
ADD switch connector
22. INSTALL GENERATOR DRIVE BELT
23. INSTALL COOLING FAN
Install the cooling fan with the four nuts.
Torque: 5.4 N–m (55 kgf–cm, 48 in.–Ibf)
24. INSTALL A/C DRIVE BELT