Disconnect High-Tension Cords From Spark Plugs; Disconnect High–Tension Cords From Distributor Cap And Ignition Coil; Reconnect High–Tension Cords To Distributor Cap And Ignition Coil - Toyota 22R-E Service Manual

IGNITION SYSTEM – (3VZ– E)
HIGH–TENSION CORDS INSPECTION
1. DISCONNECT HIGH –TENSION CORDS FROM
SPARK PLUGS
Disconnect the high – tension cords at the rubber
boot.
DO NOT pull on the cords.
NOTICE: Pulling on or bending the cords may damage
the conductor inside.
2. DISCONNECT HIGH–TENSION CORDS FROM
DISTRIBUTOR CAP AND IGNITION COIL
(a) Using a screwdriver, lift up the lock claw and dis–
connect the holder from the distributor cap (ignition
coil).
(b) Disconnect the high–tension cord at the grommet.
DO NOT pull on the cord.
NOTICE:
Pulling on or bending the cords may damage the
conductor inside.
Do not wipe any of the oil from the grommet after
the high–tension cord is disconnected.
3. INSPECT HIGH–TENSION CORD RESISTANCE
Using an ohmmeter, measure the resistance.
Maximum resistance:
25 kW per cord
If the resistance is greater than maximum, check the
terminals. If necessary, replace the high – tension
cord.
4. RECONNECT HIGH–TENSION CORDS TO
DISTRIBUTOR CAP AND IGNITION COIL
(a) Assemble the holder and grommet.
IG–19