Inspect Leakage; Install Cold Start Injector - Toyota 22R-E Service Manual

EG2–210
ENGINE – MFI SYSTEM
(f) Connect the test probes of the SST to the battery and
check that the fuel injection is as shown.
SST 09842–30050
NOTICE: Perform this check within the shortest possible
time.

2. INSPECT LEAKAGE

(a) Disconnect the test probes of SST from the battery
and check fuel leakage from the injector.
SST 09842–30050
Fuel drop:
One drop or less per minute
(b) After checking, remove SST and restore the following
parts to their original positions.
DLC1
Ignition switch OFF
Cold start injector
Injector connector
COLD START INJECTOR INSTALLATION
(See Components for Removal and Installation)

1. INSTALL COLD START INJECTOR

(a) Apply sealant to 2 or 3 threads of the bolt end.
Sealant: Part No. 08833–00070, THREE BOND 1324 or
equivalent
HINT: This adhesive will not harden while exposed to
air.
It will act as a sealant or binding agent only when
applied to threads, etc., where air is cut off.
(b) Place a new gasket and install the cold start injector
with the two nuts.
Torque: 7.8 N–m (80 kgf–cm, 69 in.–lbf)