Preparation For Disassembly - Toyota 1HD-FT Repair Manual

ENGINE - ENGINE MECHANICAL
PREPARATION FOR DISASSEMBLY
EG-65
--.
1.
MIT:
REMOVE FLYWHEEL
2. A/T:
REMOVE REAR PLATE. DRIVE PLATE AND
FLYWHEEL
3. REMOVE REAR END PLATE
4. INSTALL ENGINE TO ENGINE STAND FOR
DISASSEMBLY
5. REMOVE TIMING BELT AND PULLEYS
(See timing belt removal)
6. REMOVE CYLINDER HEAD
(See cylinder head removal)
7. REMOVE TIMING GEARS
(See timing gears removel)
B. REMOVE ALTERNATOR ADJUSTING BAR. TURBO
WATER PIPE AND WATER PUMP
(See water pump removal in Cooling System)
9. REMOVE WATER INLET AND THERMOSTAT
(See thermo.tat removal in Cooling System)
10. REMOVE ALTERNATOR AND BRACKET
ASSEMBLY
,1.
REMOVE INJECTION PUMP
(See injection pump removal in Fuel System)
12. REMOVE NO.1 CYLINDER BLOCK INSULATOR
13. REMOVE INJECTION PUMP STAY
14. REMOVE OIL PAN. OIL PUMP (TIMING GEAR CASE)
AND OIL STRAINER
(See oil pump removal in Lubrication System)
15. REMOVE OIL DIPSTICK. GUIDE AND OIL COOLER
ASSEMBLY
(See oil cooler removal in lubrication System)
16. REMOVE OIL PRESSURE SENDER GAUGE
17. REMOVE TURBO OIL HOSE
18. REMOVE ENGINE MOUNTING BRACKETS