Install Oil Pressure Sender Gauge; Install Generator Adjusting Bar; Install Water Pump - Toyota 22R-E Service Manual

ENGINE – ENGINE MECHANICAL

12. INSTALL OIL PRESSURE SENDER GAUGE

(a) Apply adhesive to two or three threads.
Adhesive:
Part No.08833–00080, THREE BOND 1344,
LOCTITE 242 or equivalent
(b) Using SST, install the oil pressure sender gauge.
SST 09816–30010
Torque: 15 N–m (150 kgf–cm. 11 ft–lbf)

13. INSTALL GENERATOR ADJUSTING BAR

14. INSTALL WATER PUMP

(a) . Remove any old packing (FIPG) material and be car–
eful not to drop any oil on the contact surfaces of the
water pump and cylinder block.
Using a razor blade and gasket scraper, remove
all the old packing (FIPG) material from the
gasket surfaces and sealing groove.
Thoroughly clean all components to remove all
the loose material.
Using a non–residue solvent, clean both sealing
surfaces.
(b) Apply seal packing to the sealing groove of the water
pump as shown in the illustration.
Seal packing:
Part No. 08826–00100 or equivalent
Install a nozzle that has been cut to a 2 – 3 mm
(0.08 – 0.12 in.) opening.
Parts must be assembled within 5 minutes of
application. Otherwise the material must be re–
moved and reapplied.
Immediately remove nozzle from the tube and
reinstall cap.
EG2–127