Full Machine Calibration; Machine Functions; How To Adjust The Machine Maximum Speed Setting - Genie S-45 XC Service And Repair Manual

July 2019
1-4

Full Machine Calibration

Full machine calibration must be completed in the
proper sequence when the ALC-600 controller
(TCON) in the ground control box has been
replaced.
How to Fully Calibrate the
Machine
Calibration procedures shall only be completed by
qualified technicians that have Genie factory
service training.
Tip-over hazard. Failure to
calibrate the machine in the
proper sequence could cause
the machine to tip over resulting
in death or serious injury.
Note: A digital level will be required to perform this
procedure.
Note: Start this procedure with the boom in the
stowed position.
Full machine calibration must be completed in the
following sequence:
• Select model, engine, tires, and region,
then cycle power. Refer to Repair Section
Display Module.
• Turntable level sensor. Refer to Repair
Procedure, How to Calibrate the Turntable
Level Sensor.
• Load cell sensor. Refer to Repair Procedure,
How to Calibrate the Load Cell Sensor.
• Primary boom angle sensor. Refer to Repair
Procedure, How to Calibrate the Primary
Boom Angle Sensor.
• Primary boom length sensor. Refer to
Repair Procedure, How to Calibrate the
Primary Boom Length Sensor.
• Select option configuration. Refer to Repair
Section, Display Module, Options.
Part No. 1286829GT S-40 XC • S-45 XC • S-40 TraX • S-45 TraX
Control System
1-5

Machine Functions

How to Adj ust the Mac hine M axim um Speed Setti ng
How to Adjust the Joystick
Maximum Speed Setting
The maximum speed of a joystick controlled
machine function can be modified from the ground
controls display. Whenever a hydraulic cylinder,
drive motor or hydraulic pump is replaced, the
maximum speed setting should be adjusted to
maintain optimum performance. The maximum
speed settings on the joystick can be changed to
compensate for hydraulic pump wear to maintain
peak performance from the machine.
Note: Perform this procedure with the boom in the
stowed position.
1 Enter the Service Mode. See Repair
Procedure, How to Enter the Service Mode.
2 Press the SETTINGS button above the display
screen.
3 Select SPEEDS from the display screen.
4 Navigate to the desired function's Maximum
Speed setting.
5 Select the desired setting to change and press
OK.
6 In the parameter adjustment screen, use the
display buttons to change the parameter. Note
that the factory default speed is considered
100% for maximum speeds.
7 Scroll and press OK. The change is effective
immediately.
8 Start the engine from the ground controls.
Service and Repair Manual
21