Platform Controls - Genie GS-2646AV Service And Repair Manual

September 2016
The platform controls are used to operate the
machine from the platform.
Activating a function button sends a signal to the
Electronic Control Module (ECM). When the ECM
is in the function mode, the platform controls are
used to operate the various machine functions.
The platform controls consist of an Emergency
Stop button, electronic circuit board, proportional
control handle, drive/steer enable switch, alarm,
function buttons and LED display.
For further information or assistance, contact
Genie Product Support.
a red Emergency Stop button P2
b platform controls circuit board U3
c proportional control handle and drive/steer
enable switch JC9
d alarm H1
Part No. 1272218
Operational Indicator Codes
These codes are generated by the electrical
system to indicate machine operating status.
During normal operation, a code will appear in the
platform controls LED readout if a condition such
as off-level, overload cutout, chassis mode
operation or pothole guard stuck occurs.
If the platform controls LED readout displays an
operational indicator code such as LL, the fault
condition must be repaired or removed before
resuming machine operation. Push in and pull out
the red Emergency Stop button to reset the
system.
Code
LL
OL
CH
PHS
nd
dE
Fd
Note: A code and a description of a code can also
be viewed at the ground controls LCD display.
GS-2646 AV • GS-2646 AV35
Service and Repair Manual

Platform Controls

Platform Controls LED Readout
Condition
Off-level
Platform Overload (CE and Australia)
Chassis Mode Operation
Pothole Guard Stuck
No Drive (option)
Deck Extended (PED only)
(lift and drive disabled)
Function Disabled (all functions)
11