Power Indicator - Panasonic PT-SW280A Operating Instructions Manual

Removing the power cord
1)
Ensuring the projector is in standby mode. Pull down the power cord safety hook and make the hook in the
bottom position.
2) Disconnect the power cord and remove the power cord safety hook.

Power indicator

Displays the status of the power. Check the status of the power indicator <ON(G) / STANDBY(R)> before
operating the projector.
Indicator status
Off The power cord is unplugged.
The power is switched off (in standby mode). The [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO].
Lighting
Red
The power is switched off (in standby mode). The [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL].
*1
Blinking
The projector is cooling down.
Orange Lighting
The power is switched off after a while. (Changes to the standby mode.)
Lighting Projecting.
The power is on and the lamp is not working. The [ECO MANAGEMENT] → [POWER MANAGEMENT] is set to
*2
Blinking
Green
[READY].
*3
Blinking The lamp starts work. The projector will project image after a while.
*1 The indicator will light as the following order:
2.75 seconds (light) → 0.25 seconds (off)
*2 The indicator will light as the following order:
2.0 seconds (light) → 2.0 seconds (off)
*3 The indicator will light as the following order:
0.5 seconds (light) → 0.5 seconds (off)
Chapter 3 Basic Operations — Switching on/off the projector
PT-SX320A
Power indicator <ON(G) / STANDBY(R)>
Status
ENGLISH - 35