[Eco Management] - Panasonic PT-SW280A Operating Instructions Manual

[ECO MANAGEMENT]

This function optimizes lamp power according to the operating status to reduce power consumption.
Setting [AUTO POWER SAVE]
Set whether or not to enable the [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTE
DETECTION] functions.
Press as to select [ECO MANAGEMENT].
1)
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
Press as to select [AUTO POWER SAVE].
3)
Press qw to switch the item.
4)
f The items will switch each time you press the button.
[OFF]
[ON]
Press as to select [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] or [AV MUTE DETECTION].
5)
[AMBIENT LIGHT DETECTION] Adjusts the power of the lamp according to the brightness of the installation location.
[SIGNAL DETECTION]
[AV MUTE DETECTION]
Press qw to switch the item.
6)
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f Lamp power cannot be reduced automatically in the following cases:
- When the lamp lighting is just completed or the setting of [LAMP POWER] is just completed, etc..
f When [AUTO POWER SAVE] is set to [OFF], settings of [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTE
DETECTION] are unavailable.
f When [LAMP POWER] is set to [ECO], settings of [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTE DETECTION]
are unavailable.
f When objects, etc. are placed around the luminance sensor on the top of the projector, [AMBIENT LIGHT DETECTION] may not function
properly.
Setting [POWER MANAGEMENT]
Set the operation as following if there is no signal input.
Press as to select [ECO MANAGEMENT].
1)
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
Press as to select [POWER MANAGEMENT].
3)
Press qw to switch the item.
4)
f The items will switch each time you press the button.
[OFF]
[READY]
[SHUT DOWN]
72 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the energy conservation setting.
Enables the energy conservation setting.
Lowers the power of the lamp when there is no signal.
Lowers the power of the lamp when the [AV MUTE] is [ON].
Disables the setting.
Enables the setting.
Power management function is off.
The countdown timer is displayed after 30 seconds without input signal. The projection lamp turns off
and cools down when reaching the set time, meanwhile the projector is in the power management
mode. The projection lamp will be turned on if the input signal is reconnected or any button is pressed.
The countdown timer is displayed after 30 seconds without input signal. The projection lamp is turned
off and cooled down when reached the set time, then the projector enter into standby status.