Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
Power indicator
Indicate the status of the power. Check the status of the power indicator <开（绿）/待机（红）> before operating
the projector.
Indicator status
Off
Red
Green
Orange
Note
f While the power indicator <开（绿）/待机（红）> lights in orange, the fan is running to cool the projector.
f For approximately five seconds after the projector is turned off, the indicator does not light up even if the power is turned on. Turn on the
power again after the power indicator <开（绿）/待机（红）> lights/blinks in red.
f The projector consumes power even in standby mode (power indicator <开（绿）/待机（红）> lights/blinks in red). Refer to "Power
consumption" (x page 228) for the power consumption.
f When the projector receives the signal from the remote control, the power indicator <开（绿）/待机（红）> will blink in the following color
according to the status of the projector.
g When the projector is in projection mode: Green
g When the projector is in standby mode: Orange
However, if the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO], the indicator will stay lit in red and will not blink if the
projector is in standby mode.
f The power indicator <开（绿）/待机（红）> will blink slowly in green while the shutter function is in use (shutter: closed), or while the
function of the [PROJECTOR SETUP] menu → [NO SIGNAL SETTING] → [NO SIGNAL LIGHTS-OUT] is operating and the light source is
turned off.
Power indicator < 开 （绿） ／ 待机 （红） >
The main power is switched off.
The power is switched off. (standby mode)
Projection will start when the power on <b> button is pressed.
f The setting of the projector is as follows.
Lit
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [OFF].
f The projector may not operate when the light source indicator <光源> or the
temperature indicator <温度> is blinking. (x page 197)
The power is switched off. (standby mode)
Projection will start when the power on <b> button is pressed.
f The setting of the projector is as follows.
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON].
f The indicator will change to a red light when the specified time has elapsed after the
projector enters the standby mode if the projector is set as following.
Blinking
The specified time is the time set in the [PROJECTOR SETUP] menu → [QUICK
STARTUP] → [VALID PERIOD].
g The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON].
f The projector may not operate when the light source indicator <光源> or the
temperature indicator <温度> is blinking. (x page 197)
Lit
Projecting.
The projector is preparing to switch off the projector.
Lit
The power is switched off after a while. (Changes to the standby mode.)
Projector status
ENGLISH - 51
Advertisement
Table of Contents
