Switching the input by displaying the input guide
The input for projection can be selected by displaying the input guide with the control panel.
1)
Press the <INPUT SELECT> button on the control panel.
f The [DETAILED] input guide or the [SIMPLE] input guide is displayed. ( x page 63)
2)
Press the <INPUT SELECT> button again.
f The input will switch each time you press the <INPUT SELECT> button.
f You can also select the input source by pressing qw on the remote control or the control panel from the
[DETAILED] input guide.
Note
f The input guide for [DETAILED]/[SIMPLE], you can change the setting from the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] →
[INPUT GUIDE].
Adjusting the image
Adjust the position, size and focus of the projected image.
1)
Adjust the projection angle.
f Install the projector on a horizontal location as the front surface of the projector is parallel to the screen
surface so that the projected screen is rectangular.
f If the screen is tilted downward, extend the adjustable feet and adjust the projection screen so that the
projected screen is rectangular.
f Refer to "Adjusting adjustable feet" ( x page 29) for details.
2)
Adjust the zoom and focus.
f Adjust the projected image size by turning the zoom lever.
f Adjust the focus by turning the focus lever.
Note
f It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
f Turning the focus lever changes the projection screen size. Make fine adjustments again to the projection screen size by turning the zoom
lever.
f When there is distortion, execute the [POSITION] menu → [SCREEN ADJUSTMENT].
Chapter 3 Basic Operations — Projecting
The input guide for [DETAILED]
The input guide for [SIMPLE]
If there is no signal input ([COMPUTER],
or [HDMI]), this screen will be displayed.
Check the output settings of your computer.
Zoom lever
Focus lever
ENGLISH - 41