Table of Contents
Advertisement
Note
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer
control.
If multiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectors with other ID
numbers.
f Refer to "Setting the ID number of the remote control" (
[INITIAL START UP]
Set the method of start up when the power cord plugged into the AC outlet.
Press as to select [INITIAL START UP].
1)
Press qw to switch the item.
2)
f The items will switch each time you press the button.
[LAST MEMORY]
[STANDBY]
[ON]
[PROJECTION METHOD]
Set the projection method in accordance with the installation status of the projector.
Change the projection method if the screen display is upside down or inverted.
Press as to select [PROJECTION METHOD].
1)
Press qw to switch the projection method.
2)
f The items will switch each time you press the button.
[AUTO]
[FRONT/DESK]
[FRONT/CEILING]
[REAR/DESK]
[REAR/CEILING]
Note
f When set to [AUTO], front projection or rear projection cannot be detected. When projecting from rear, please set the [PROJECTION
METHOD] to [REAR/DESK] or [REAR/CEILING].
f As for the range of installation posture detected by the projector's built-in angle sensor, please refer to "Angle sensor". ( x page 26)
[LAMP POWER]
Switch the brightness of the lamp according to the operating environment of the projector or the purpose.
Press as to select [LAMP POWER].
1)
Press qw to switch the item.
2)
f The items will switch each time you press the button.
[NORMAL]
[ECO]
Note
f Set it to [ECO] rather than [NORMAL] when you want to reduce power consumption, extend the life of lamp and reduce operation noise.
f The [LAMP POWER] changes to [ECO] forcibly to protect the projector when the operating environment temperature becomes 35 °C (95 °F)
or higher (30 °C (86 °F) or higher when used at high altitude). And, even if the [PROJECTOR SETUP] menu → [LAMP POWER] is set to
[NORMAL], the [LAMP POWER] changes to [ECO] automatically.
[LAMP RUNTIME]
Displays the runtime of the lamps
Be sure to reset the [LAMP RUNTIME] after replacing the lamp unit, refer to "Lamp unit replacement time"
( x page 104)
Chapter 4 Settings — [PROJECTOR SETUP] menu
Æ
page 46) for how to set the ID number on the remote control.
Starts in the condition that before disconnected the power cord or turn off the breaker.
Starts up in the standby mode.
Starts the projection immediately.
The projector's posture can be detected automatically by the built-in angle sensor, then switch to
[FRONT/DESK] or [FRONT/CEILING]. When projecting in front of the screen, please set to [AUTO].
When installing the projector on the desk, etc., in front of the screen.
When installing the projector in front of the screen with the Ceiling Mount Bracket (optional).
When installing the projector on the desk, etc., behind the screen (with a translucent screen).
When installing the projector behind the screen (with a translucent screen) with the Ceiling Mount
Bracket (optional).
Select when high luminance is required.
Select when high luminance is not required.
ENGLISH - 71
Advertisement
Table of Contents
