Preparing The Remote Control; Inserting And Removing The Batteries; When Using The System With Multiple Projectors - Panasonic PT-SW280A Operating Instructions Manual

Preparing the remote control

Inserting and removing the batteries

(i)
Open the cover. (Fig. 1)
1)
Insert the batteries and close the cover (insert the m side first). (Fig. 2)
2)
f When removing the batteries, perform the steps in reverse order.

When using the system with multiple projectors

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each
projector individually by using single remote control, if a unique ID number is assigned to each projector.
When you want to set the ID number, at first you need to complete the Initial setting, and then after setting the ID
number of the projector, set the ID number on the remote control.
About Initial setting, please refer to "When the initial setting screen is displayed" ( x page 36).
The factory default ID number of the unit (the projector and the remote control) is set to [ALL], you can control with
this setting. If necessary, please set the ID number to the remote control and the projector.
About how to set the ID number of the remote control, please refer to "Setting the ID number of the remote control"
( x page 46).
Note
f Set the ID number of the projector from the [PROJECTOR SETUP] menu → [PROJECTOR ID] ( x page 70).
24 - ENGLISH
Chapter 1 Preparation — Preparing the remote control
(ii)
Fig.1 Fig.2