[Control Device Setup] - Panasonic PT-SW280A Operating Instructions Manual

[CONTROL DEVICE SETUP]

Enable/disable the button operations on the control panel and the remote control.
Press as to select [CONTROL DEVICE SETUP].
1)
2)
Press the <ENTER> button.
f The [CONTROL DEVICE SETUP] screen is displayed.
Press as to select [CONTROL PANEL] or [REMOTE CONTROLLER].
3)
[CONTROL PANEL]
[REMOTE CONTROLLER]
Press qw to switch between [ENABLE] and [DISABLE].
4)
f You can set the limitation on the control by the control panel or the remote control.
[ENABLE]
[DISABLE]
f A confirmation screen will be displayed when you change [ENABLE] to [DISABLE], then proceed to Step 5).
Press qw to select [OK], and then press the <ENTER> button.
5)
Note
f When a button operation is performed on the device set to [DISABLE] , the [PASSWORD] screen is displayed.
To continue operations, enter the security password.
f The [PASSWORD] screen will disappear when there is no operation for approx.10 seconds.
f If the operations of both [CONTROL PANEL] and [REMOTE CONTROL] are set to [DISABLE], the projector cannot be turned off (cannot
enter standby).
f Even when you set button operations on the remote control to be disabled, operations of the <ID ALL> and <ID SET> buttons on the remote
control are enabled.
Chapter 4 Settings — [SECURITY] menu
You can set the limitation on the control from the control panel.
You can set the limitation on the control from the remote control.
Enable the button operations.
Disable the button operations.
ENGLISH - 79