Panasonic PT-SW280A Operating Instructions Manual page 68

Setting the countdown timer
Press as to select [P-TIMER].
1)
2)
Press the <ENTER> button.
f The [P-TIMER] screen is displayed.
Press as to select [TIMER].
3)
Press qw to set the time.
4)
f The time can be set in 1-minute increments from 1 to 180 minutes.
f The factory default value is 10 minutes.
Note
f [TIMER] is enabled when [MODE] is set to [COUNT DOWN].
Using the presentation timer
Press as to select [P-TIMER].
1)
2)
Press the <ENTER> button.
f The [P-TIMER] screen is displayed.
Press as to select the item, and press the <ENTER> button.
3)
[START]
[STOP]
[RESTART]
[RESET]
f When [START] or [RESTART] is selected, the elapsed time or the remaining time is displayed at the bottom
right of the projected image.
f When [STOP] is selected, the elapsed time or the remaining time when the count was stopped is displayed
at the bottom right of the projected image.
f When [RESET] is selected, proceed to Step 4).
4)
Press the <MENU> button three times, then menu screen will disappear.
f The P-TIMER function is cancelled.
Note
f Presentation timer operations are also possible by the <P-TIMER> button on the remote control. ( x page 45)
f The security message set in the [SECURITY] menu → [TEXT DISPLAY ] ( x page 78) is not displayed when the elapsed time or
remaining time is displayed.
f The elapsed time or remaining time are not displayed when the menu screen is displayed.
f The start time becomes "000:00" when [MODE] is set to [COUNT UP].
f When [MODE] is set to [COUNT DOWN], the start time becomes the value set at [TIMER].
f The time gauge turns clockwise when [COUNT UP] is set, and turns counterclockwise when [COUNT DOWN] is set.
Ending the presentation timer
Press as to select [P-TIMER].
1)
2)
Press the <ENTER> button.
f The [P-TIMER] screen is displayed.
Press as to select [EXIT].
3)
4)
Press the <ENTER> button.
68 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
The count is started.
The count is stopped.
The count is resumed.
The count is reset.