Projector Body - Panasonic PT-SW280A Operating Instructions Manual

Note
f When operating the remote control by directly pointing the remote control signal receiver of the projector, operate the remote control at a
distance approx.7 m (22'11-5/8'') or shorter from the remote control signal receiver. The remote control can control at angles of up to ±30°
vertically and horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
f The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.
f If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Use
it in a place distant from the light source.
f The power indicator <ON(G) / STANDBY(R)> will blink if the projector receives a remote control signal.

Projector body

r Front
r Rear
5
Projection direction
WARNING
Keep your hands and other objects away from the air exhaust
port.
f Keep your hands and face away.
f Do not insert your fingers.
f Keep heat-sensitive objects away.
Heated air from the air exhaust port can cause burns, injury, or
deformations.
Chapter 1 Preparation — About your projector
1 2
6 7
r Side
3
8
1 Remote control signal receiver
2 Projection lens
3 Air exhaust port
4 Speaker
5 Security slot
This security slot is compatible with the Kensington security
cables.
6 <AC IN> terminal
Connect the supplied power cord.
Connecting terminals ( x page 23)
7
Air filter
8
4
ENGLISH - 21