Switching On The Projector; When The Initial Setting Screen Is Displayed - Panasonic PT-SW280A Operating Instructions Manual

Switching on the projector

Before switching on the projector, make sure all the other devices are correctly connected ( x page 30).
1)
1)
Connect the power cord to the projector body.
2)
Connect the power plug to an outlet.
f The power indicator <ON(G) / STANDBY(R)> lights or blinks in red, and the projector enters the standby
mode.
3)
Press the power <v/b> button.
f The power indicator <ON(G) / STANDBY(R)> lights in green and the image is soon projected on the screen.
Note
f If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], compare with it is set to [NORMAL],
it is about 10 seconds later for the start times of the projection after open the projector.

When the initial setting screen is displayed

When the projector is switched on for the first time after purchase as well as when [INITIALIZE ALL] in the [PROJECTOR
SETUP] menu is executed, the [INITIAL SETTING] screen is displayed. Set them in accordance with circumstances.
In other occasions, you can change the settings by menu operations.
If you press the <RETURN> button or the <MENU> button while the [INITIAL SETTING] screen is displayed, you can go back
to the previous screen.
Note
f When the projector is used for the first time, in order to clearly display the menu screen, it is required to adjust the focus lever and the zoom
lever. For details, refer to "Adjusting the image" ( x page 41)
36 - ENGLISH
Chapter 3 Basic Operations — Switching on/off the projector
2)
3)
3)