Siemens Simatic ET 200S Operating Instructions Manual page 57

2AI RTD HF
2AI TC ST
2AI TC HF
2AO U ST
2AO U HF
2AO I ST
2AO I HF
1COUNT 24V/100kHz
1COUNT 5V/500kHz
1SSI
1STEP 5V/204kHz
2PULSE
1POS INC/Digital
1POS SSI/Digital
1POS INC/Analog
1POS SSI/Analog
1SI 3964/ASCII
1SI Modbus/USS
4 IQ-SENSE
Motor starter STANDARD
Motor starter HIGH FEATURE
1) Cycle synchronization is activated
2) For application as 2AI RTD ST
3) For application as 6ES7 134-4GB50-0AB0
4) For application as 6ES7 134-4FB50-0AB0
5) For application as 6ES7 134-4GB60-0AB0
6) Is not relevant as from 6ES7151-1BA01-0AB0
Note
With the IM151-1 HIGH FEATURE (6ES7151-1BA01-0AB0) you have the possibility to
configure more than 244 byte parameter data in
length is greater than 244 bytes, an increase in the startup time is to be expected.
ET 200S
Operating Instructions, 12/2005, A5E00515771-03
3.3 Limitation of connectable modules/maximum configuration
Module Parameter length per module
7 bytes
(4 bytes )
2
4 bytes
7 bytes
7 bytes
16 bytes
16 bytes
8 bytes
7 bytes
16 bytes
16 bytes
4/8 bytes
16 bytes
3 bytes
12 bytes
STEP 7
in DPV1 mode. If the parameter
Application planning
3-11