Enable Startup For Set <> Actual Configuration - Siemens Simatic ET 200S Operating Instructions Manual

Integrated periphery 32DI
Diagnostics: Short-circuit
sensor supply voltage group n
Diagnostics: load voltage
missing voltage group n
Integrated periphery 16DI/16DO
Diagnostics: Short-circuit
sensor supply voltage group 0
Diagnostics: load voltage
missing voltage group n
Behavior in event of
CPU/master STOP
Substitution value
The parameter only exists when configuring via the GSD file.
1
If the supply voltage to the COMPACT module fails, the digital outputs will not supply a substitute
2
value. Output value = 0
11.3.2 Enable startup for set <> actual configuration
When this parameter is enabled, and
• modules next to IM151-1 COMPACT are removed and plugged during operation, then a
• The actual configuration differs from the expected configuration, the ET 200S remains
When this parameter is disabled, and
• modules next to IM151-1 COMPACT are removed and plugged during operation, then a
• The actual configuration differs from the expected configuration, there is no data transfer
11.3.3 Analog-value format
Here you set the number format for all analog electronic modules positioned next to the
IM151-1 COMPACT.
ET 200S
Operating Instructions, 12/2005, A5E00515771-03
11.3 Parameters and parameter descriptions for COMPACT modules
IM151-1 COMPACT
2
station failure of ET 200S will not occur.
engaged in data transfer with the DP master.
station failure of ET 200S will occur.
between the DP master and the ET 200S.
Value range
disable/enable disable
disable/enable Disable
disable/enable Disable
disable/enable Disable
Switch substitution Switch substitution
value / hold last value value
"0"/ "1" "0"
COMPACT modules
Default setting Applicability
Voltage group
voltage group
Voltage group
Voltage group
Module
Channel
11-3