Siemens Simatic ET 200S Operating Instructions Manual page 253

Compatibility of the interface module IM151-3 PN HIGH FEATURE (6ES7151-3BA20-0AB0)
Note
Firmware version of the controller used
To be able to operate the IM -3151 PN HIGH FEATURE (6ES7151-3BA20-0AB0) interface
module on a controller, operate the latter using one of the firmware versions listed below.
The following firmware versions are compatible with the interface module IM 151-3 PN HIGH
FEATURE (6ES7151-3BA20-0AB0):
Controller 315-2 PN/DP
317-2 PN/DP
Firmware version
For IM151-3 HIGH FEATURE V2.3 is required for the use of fail-safe PROFIsafe modules at the IM151-3 HIGH
1
FEATURE.
For IM151-3 STANDARD and HIGH FEATURE. An operation of fail-safe PROFIsafe modules with IM151-3 HIGH
2
not
FEATURE is possible via the CP343.
SNMP
The IM151-3 PN HIGH FEATURE supports the Ethernet service SNMP. MIB-2 (RFC1213) is
supported. R/W objects are changeable using SNMP tools and are stored in the device.
Remanent stored SNMP parameters are reset to default settings (STEP 7 V5.3 SP 3 and
higher) in HW Config dialog "Target system > Ethernet > Edit Ethernet nodes" "Reset" button
under "Reset to default settings".
After exchange for a factory-new device, the R/W objects in the IM151-3 PN HIGH
FEATURE are set to default settings.
Restrictions when operating the modules with the IM 151-3 PN HIGH FEATURE
The following modules cannot be used with the IM-151 HIGH FEATURE:
2AO U; HIGH FEATURE
2AO I; HIGH FEATURE
1SI serial interface module
Modbus/USS serial interface module
ET 200S
Operating Instructions, 12/2005, A5E00515771-03
10.9 Interface module IM151-3 PN HIGH FEATURE (6ES7151-3BA20-0AB0)
CPU
317F-2 PN/DP
≥ V2.3.2 ≥ V2.3.3
Module
CP
443-1 343-1
Advanced
≥ V2.3 ≥1.1
1 2
Up to order number
6ES7135-4LB01-0AB0
6ES7135-4MB01-0AB0
6ES7138-4DF00-0AB0
6ES7138-4DF10-0AB0
Interface modules
SOFTNET PNIO
343-1 SIMATIC NET-CD
Advanced
≥1.0 V 6.3 Hotfix 1
2
Up to product version
3
3
4
4
10-31