New Information About The "Et 200S Distributed I/O System Operating Instructions; Identification Data - Siemens Simatic ET 200S Operating Instructions Manual

New Information About the "ET 200S Distributed I/O
System Operating Instructions"
Introduction
This information is new and replaces the information in Sections 7.4, 8.1.3, 8.2.3 and
8.1.4.10 in the
release 12/2005.
4.11

Identification Data

0
Reading of identification data
Table 2-1 Identification Data
Identification Data
Identification data 0: Index 1 (Data record 231)
MANUFACTURER_ID
ORDER_ID
SERIAL_NUMBER
HARDWARE_REVISION
SOFTWARE_REVISION
REVISION_COUNTER
PROFILE_ID
PROFILE_SPECIFIC_TYPE
IM_VERSION
IM_SUPPORTED
ET 200S
Product Information, 03/2006, A5E00743001-01
ET 200S Distributed I/O System Operating Instructions
Access
Read (2 bytes) 2A hex (= 42 dec)
Read (20 bytes) Depends on the
module
Read (16 bytes) not relevant
Read (2 bytes) not relevant
Read (4 bytes) Firmware version
Read (2 bytes) -
Read (2 bytes) F600 hex
Read (2 bytes) 0003 hex
0005 hex
Read (2 bytes) 0101 hex
Read (2 bytes) 000E hex
Default setting
The name of the manufacturer is stored
here. (42 dec = SIEMENS AG)
Order number of the module
This indicates the firmware version of the
module.
Provides information on parameter
modifications on the module.
Generic Device
On electronic modules
on interface modules
Provides information on the ID data version
(0101 hex = version 1.1)
Provides information on existing
identification data (index 2 to 4)
2
(A5E00515771-03),
Explanation
2-1