H Status - Siemens Simatic ET 200S Operating Instructions Manual

Alarm, error and system messages
8.1 Alarm, error and system messages on PROFIBUS DP
Error class
27 11011: Unclear error
D
8.1.4.9

H status

Requirements
The H status in the diagnostic frame supplies the IM151-1 HIGH FEATURE only when
operated behind a Y link (e. g. IM 157) in DPV1 mode. This block can be ignored when
evaluating the diagnostic frame. The configuration is described in the following section.
Structure of the H status
Figure 8-10
8-42
Meaning
Teach-in
operation is running.
Alignment tool is active.
Structure of the H status of the IM151-1 HIGH FEATURE
Remedy
Teach-in
Terminate the
Close the alignment tool.
Operating Instructions, 12/2005, A5E00515771-03
operation.
ET 200S