Siemens Simatic ET 200S Operating Instructions Manual page 245

Compatibility of the IM151-3 PN interface module (6ES7151-3AA10-0AB0 and higher)
Note
Firmware version of the controller used
To be able to operate the IM -3151 PN (6ES7 151-3AA10-0AB0 and higher) interface
module on a controller, operate the latter using one of the firmware versions listed below.
You can utilize the interface module IM151-3 PN (6ES7151-3AA00-0AB0) independently of
the controller firmware version.
The following firmware versions are compatible with the interface module IM 151-3 PN
(6ES7151-3AA10-0AB0 and higher):
Controller
Firmware version
Note
Spare-part application of an IM151-3 PN (6ES7151-3AA10-0AB0)
If a spare part is required, you can replace an IM151-3 PN (6ES7151-3AA10-0AB0) by an
IM151-3 PN (6ES7151-3AA20-0AB0) if the following conditions are fulfilled:
• 15 mm free space to the left of the IM151-3 PN
•
• The user program is adapted in accordance with the "From PROFIBUS DP to PROFINET
Restrictions when operating the modules with the IM151-3 PN
The following modules cannot be used with the IM151-3 PN:
2AO U; HIGH FEATURE
2AO I; HIGH FEATURE
1SI serial interface module
Modbus/USS serial interface module
ET 200S
Operating Instructions, 12/2005, A5E00515771-03
315-2 PN/DP
317-2 PN/DP
≥ V2.3.2
STEP7
V5.3 ServicePack 3
IO" programming manual, Version 01/06.
Module
10.8 Interface module IM151-3 PN (6ES7151-3AA20-0AB0)
CPU
443-1
≥ V2.2
Up to order number
6ES7135-4LB01-0AB0
6ES7135-4MB01-0AB0
6ES7138-4DF00-0AB0
6ES7138-4DF10-0AB0
Interface modules
CP SOFTNET PNIO
343-1 SIMATIC NET-CD
≥2.0
Up to product version
V 6.3 Hotfix 1
3
3
4
4
10-23