Layer 3 Edge Aggregate Interface Configuration Example - H3C S7500E-X Configuration Manual

Aggregate Interface: Route-Aggregation2
Aggregation Mode: Static
Loadsharing Type: Shar
Port
--------------------------------------------------------------------------------
GE1/0/3
GE1/0/4
The output shows that:
•
Link aggregation groups 1 and 2 are both load-shared Layer 3 static aggregation groups.
•
Each aggregation group contains two Selected ports.
# Display all the group-specific load sharing modes on Device A.
[DeviceA] display link-aggregation load-sharing mode interface
Route-Aggregation1 Load-Sharing Mode:
source-ip address
Route-Aggregation2 Load-Sharing Mode:
destination-ip address
The output shows that:
•
Link aggregation group 1 load shares packets based on source IP addresses.
•
Link aggregation group 2 load shares packets based on destination IP addresses.

Layer 3 edge aggregate interface configuration example

Network requirements
As shown in
link. Configure an edge aggregate interface so that GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2
can forward packets from the server during the server reboot process.
Figure 16 Network diagram
Configuration procedure
Configure the device:
1.
# Create Layer 3 aggregate interface Route-Aggregation 1, and set the link aggregation mode
to dynamic.
<Device> system-view
[Device] interface route-aggregation 1
[Device-Route-Aggregation1] link-aggregation mode dynamic
# Configure an IP address and subnet mask for Layer 3 aggregate interface Route-Aggregation
1.
[Device-Route-Aggregation1] ip address 192.168.1.1 24
# Configure Layer 3 aggregate interface Route-Aggregation 1 as an edge aggregate interface.
Status Priority Oper-Key
S 32768
S 32768
Figure 16, the device and the server are the two ends of a Layer 3 dynamic aggregate
2
2
52