H3C S7500E-X Configuration Manual page 285

setting Ethernet link aggregation load sharing
mode (global), 37
setting Ethernet link aggregation load sharing
mode (group-specific), 38
setting Layer 3 aggregate interface (MTU), 34
setting LLDP bridge mode, 224
setting LLDP DCBX version, 234
setting LLDP frame encapsulation format, 230
setting LLDP operating mode, 224
setting LLDP parameters, 229
setting LLDP reinitialization delay, 225
setting loop detection interval, 110
setting loop detection protection action
(global), 110
setting loop detection protection action (Layer
2 aggregate interface), 110
setting loop detection protection action (Layer
2 Ethernet interface), 110
setting MAC address table dynamic aging
timer, 6
setting MAC address table learning limit (on
interface), 7
setting MAC Information change notification
interval, 17
setting MAC Information mode, 16
setting MAC Information queue length, 17
setting QinQ SVLAN tag 802.1p priority, 193
setting spanning tree mode, 75
shutting down Ethernet link aggregate
interface, 36
specifying Layer 2 aggregate interface
(ignored VLAN), 33
specifying spanning tree port path cost
calculation standard, 81
promiscuous
private VLAN promiscuous port
configuration, 146
private VLAN trunk promiscuous port
configuration, 148
private VLAN trunk promiscuous+trunk
secondary port configuration, 152
protecting
loop detection protection action setting, 109
spanning tree protection features, 94
spanning tree SNMP notification (new-root
election, topology change events), 98
protocol-based VLAN
configuration, 126, 133
protocols and standards
Ethernet link aggregation protocol
configuration, 21
LLDP, 223
MSTP, 71
MVRP, 175
QinQ, 190
STP protocol packets, 58
VLAN, 115
PVID (port-based VLAN), 117
PVST, 58, See also STP
configuration, 73, 103
feature enable, 87
mode set, 75
port links, 65
Q
QinQ
basic configuration, 195
configuration, 189, 195
configuration restrictions, 191
CVLAN tag, 189
display, 194
enable, 191
how it works, 189
implementation, 190
loop detection configuration, 107, 109, 111
protocols and standards, 190
SVLAN tag, 189
SVLAN tag 802.1p priority, 193
VLAN tag TPID value, 192
VLAN transparent transmission, 191
VLAN transparent transmission
configuration, 197
QoS
LLDP 802.1p-to-local priority mapping, 236
LLDP APP parameters, 234
LLDP DCBX version, 234
LLDP ETS parameters, 236
LLDP group-based WRR queuing, 237
LLDP PFC parameters, 238
QinQ SVLAN tag 802.1p priority, 193
voice VLAN QoS priority setting
configuration, 163
queuing
MAC Information queue length, 17
R
Rapid Spanning Tree Protocol. Use RSTP
rate
spanning tree BPDU transmission rate, 80
receiving
LLDP frames, 223
recovering
loop detection port status auto recovery, 108
reference port (Ethernet link aggregation), 22, 25
272