Configuring A Static Aggregation Group - H3C S7500E-X Configuration Manual

AC-VSI association (see MPLS Configuration Guide).
•
You cannot assign a port to a Layer 3 aggregation group if any of the following features are
configured on the port:
Association between AC and cross connection (see MPLS Configuration Guide).
AC-VSI association (see MPLS Configuration Guide).
•
An RPR logical interface cannot be assigned to an aggregation group whose corresponding
aggregate interface is assigned to an isolation group. For information about isolation groups,
see "Configuring port
•
Do not assign a reflector port for port mirroring to an aggregation group. For more information
about reflector ports, see Network Management and Monitoring Configuration Guide.
•
Deleting an aggregate interface also deletes its aggregation group and causes all member
ports to leave the aggregation group.
•
You must configure the same aggregation mode on the two ends of an aggregate link.

Configuring a static aggregation group

To guarantee a successful static aggregation, make sure the ports at both ends of each link are in the
same aggregation state.
Configuring a Layer 2 static aggregation group
Step
Enter system view.
1.
Create a Layer 2 aggregate
2.
interface and enter Layer 2
aggregate interface view.
Exit to system view.
3.
Assign an interface to the
4.
specified Layer 2
aggregation group.
(Optional.) Set the port
5.
priority for the interface.
Configuring a Layer 3 static aggregation group
Step
Enter system view.
1.
isolation."
Command
system-view
interface bridge-aggregation
interface-number
quit
a. Enter Layer 2 Ethernet
interface view or RPR
logical interface view:
interface interface-type
interface-number
b. Assign the interface to
the specified Layer 2
aggregation group:
port link-aggregation
group number
link-aggregation port-priority
port-priority
Command
system-view
29
Remarks
N/A
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
N/A
Repeat these two substeps to
assign more Layer 2 Ethernet
interfaces or RPR logical
interfaces to the aggregation
group.
You cannot assign Layer 2
Ethernet interfaces and RPR
logical interfaces to the same
Layer 2 aggregation group. You
can assign only two RPR logical
interfaces to a Layer 2
aggregation group.
The default port priority of an
interface is 32768.
Remarks
N/A