H3C S7500E-X Configuration Manual page 60

Figure 12 Network diagram
Configuration procedure
Configure the device:
1.
# Create Layer 2 aggregate interface Bridge-Aggregation 1, and set the link aggregation mode
to dynamic.
<Device> system-view
[Device] interface bridge-aggregation 1
[Device-Bridge-Aggregation1] link-aggregation mode dynamic
# Configure Layer 2 aggregate interface Bridge-Aggregation 1 as an edge aggregate interface.
[Device-Bridge-Aggregation1] lacp edge-port
[Device-Bridge-Aggregation1] quit
# Assign ports GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 to link aggregation group 1.
[Device] interface gigabitethernet 1/0/1
[Device-GigabitEthernet1/0/1] port link-aggregation group 1
[Device-GigabitEthernet1/0/1] quit
[Device] interface gigabitethernet 1/0/2
[Device-GigabitEthernet1/0/2] port link-aggregation group 1
[Device-GigabitEthernet1/0/2] quit
Configure the server as required. (Details not shown.)
2.
Verifying the configuration
# Display detailed information about all aggregation groups on the device during the server reboot
process.
[Device] display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Bridge-Aggregation1
Aggregation Mode: Dynamic
Loadsharing Type: Shar
System ID: 0x8000, 000f-e267-6c6a
Local:
Port
--------------------------------------------------------------------------------
GE1/0/1
GE1/0/2
Remote:
Actor
--------------------------------------------------------------------------------
GE1/0/1
Status Priority Oper-Key
I 32768 1
I 32768 1
Partner Priority Oper-Key
0 32768 0
Flag
{AG}
{AG}
SystemID
0x8000, 0000-0000-0000 {DEF}
47
Flag