Assigning A Hybrid Port To A Vlan - H3C S7500E-X Configuration Manual

Step
(Optional.) Configure the
5.
PVID of the trunk port.

Assigning a hybrid port to a VLAN

A hybrid port supports multiple VLANs. You can assign it to the specified VLANs in interface view.
Make sure the VLANs have been created.
When you assign a hybrid port to a VLAN, follow these restrictions and guidelines:
•
To change the link type of a port from trunk to hybrid or vice versa, set the link type to access
first.
•
To enable a hybrid port to transmit packets from its PVID, you must assign the hybrid port to the
PVID by using the port hybrid vlan command.
To assign a hybrid port to one or multiple VLANs:
Step
Enter system view.
1.
Enter interface view.
2.
Configure the link type of the
3.
port as hybrid.
Assign the hybrid port to the
4.
specified VLANs.
(Optional.) Configure the
5.
PVID of the hybrid port.
Command
port trunk pvid vlan vlan-id
Command
system-view
•
Enter Layer 2 Ethernet
interface view, RPR logical
interface view, or Layer 2
aggregate interface view:
interface interface-type
interface-number
•
Enter S-channel interface
view:
interface s-channel
interface-number.channel-id
•
Enter S-channel aggregate
interface view:
interface
schannel-aggregation
interface-number:channel-id
port link-type hybrid
port hybrid vlan vlan-id-list
{ tagged | untagged }
port hybrid pvid vlan vlan-id
120
Remarks
The default setting is VLAN 1.
RPR logical interfaces do not
support this command.
Remarks
N/A
N/A
By default, all ports are access
ports.
By default, the hybrid port is an
untagged member of the VLAN to
which the port belongs when its
link type is access.
The untagged keyword does not
take effect on RPR logical
interfaces.
By default, the PVID of a hybrid
port is the ID of the VLAN to which
the port belongs when its link type
is access.
RPR logical interfaces do not
support this command.