H3C S7500E-X Configuration Manual page 248

Step
Enter system view.
1.
Create an Ethernet frame
2.
header ACL or an IPv4
advanced ACL and enter
ACL view.
Create a rule for the ACL.
3.
Return to system view.
4.
Create a class, specify the
5.
operator of the class as OR,
and enter class view.
Use the specified ACL as the
6.
match criterion of the class.
Return to system view.
7.
Create a traffic behavior and
8.
enter traffic behavior view.
Configure the behavior to
9.
mark packets with an 802.1p
priority.
10. Return to system view.
11. Create a QoS policy and
enter QoS policy view.
12. Associate the class with the
traffic behavior in the QoS
policy, and apply the
association to DCBX.
13. Return to system view.
Command
system-view
acl number acl-number [ name
acl-name ] [ match-order { auto |
config } ]
•
For the Ethernet frame
header ACL:
rule [ rule-id ] permit type
protocol-type ffff
•
For the IPv4 advanced ACL:
rule [ rule-id ] permit { tcp |
udp } destination-port eq
port
quit
traffic classifier classifier-name
operator or
if-match acl acl-number
quit
traffic behavior behavior-name
remark dot1p 8021p
quit
qos policy policy-name
classifier classifier-name
behavior behavior-name mode
dcbx
quit
235
Remarks
N/A
An Ethernet frame header ACL
number is in the range of 4000 to
4999. An IPv4 advanced ACL
number is in the range of 3000 to
3999.
DCBX Rev 1.00 supports only
Ethernet frame header ACLs.
DCBX Rev 1.01 and IEEE Std
802.1Qaz-2011 support both
Ethernet frame header ACLs and
IPv4 advanced ACLs.
Create rules according to the type
of the ACL previously created.
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A