Configuring Load Sharing For Link Aggregation Groups; Setting Load Sharing Modes For Link Aggregation Groups - H3C S7500E-X Configuration Manual

Step
Enter system view.
1.
Enter aggregate interface view.
2.
Restore the default settings for the
3.
aggregate interface.
Configuring load sharing for link aggregation
groups
This section explains how to configure the load sharing modes for link aggregation groups and how
to enable local-first load sharing for link aggregation.

Setting load sharing modes for link aggregation groups

You can set the global or group-specific load sharing mode. The global load sharing mode takes
effect on all aggregation groups. A link aggregation group preferentially uses the group-specific load
sharing mode. If the group-specific load sharing mode is not available, the group uses the global load
sharing mode.
Setting the global link-aggregation load sharing mode
In system view, the switch supports the following load sharing modes and combinations:
•
Source IP address.
•
Destination IP address.
•
Source MAC address.
•
Destination MAC address.
•
Source IP address and destination IP address.
•
Source IP address and source port.
•
Destination IP address and destination port.
•
Source IP address, source port, destination IP address, and destination port.
•
Any combination of ingress port, source MAC address, and destination MAC address.
To set the global link-aggregation load sharing mode:
Step
Enter system view.
1.
Set the global
2.
link-aggregation load
sharing mode.
Command
system-view
•
Enter Layer 2 aggregate interface view:
interface bridge-aggregation interface-number
•
Enter Layer 3 aggregate interface view:
interface route-aggregation interface-number
default
Command
system-view
link-aggregation global
load-sharing mode { destination-ip |
destination-mac | destination-port |
ingress-port | source-ip |
source-mac | source-port } *
37
Remarks
N/A
By default, the device load shares
traffic automatically based on
packet types.