Configuring An Aggregation Group; Configuration Restrictions And Guidelines - H3C S7500E-X Configuration Manual

Tasks at a glance
(Optional.) Configuring an aggregate interface:
•
Setting the description for an aggregate interface
•
Specifying ignored VLANs for a Layer 2 aggregate interface
•
Reserving a VLAN interface resource for a Layer 2 aggregate interface
•
Setting the MTU for a Layer 3 aggregate interface
•
Setting the minimum and maximum numbers of Selected ports for an aggregation group
•
Setting the expected bandwidth for an aggregate interface
•
Configuring an edge aggregate interface
•
Shutting down an aggregate interface
•
Restoring the default settings for an aggregate interface
(Optional.) Configuring load balancing for link aggregation group:
•
Setting load sharing modes for link aggregation groups
•
Enabling local-first load sharing for link aggregation
Enabling link-aggregation traffic redirection

Configuring an aggregation group

This section explains how to configure an aggregation group.

Configuration restrictions and guidelines

When you configure an aggregation group, follow these restrictions and guidelines:
•
RPR logical interfaces cannot be assigned to dynamic aggregation groups.
•
The maximum number of aggregation groups and the maximum number of Selected ports
allowed in an aggregation group depend on the location of member ports, as shown in the
following matrix:
Member port location
Some member ports
or the ingress ports
of the traffic are on
any of these OAP
modules.
No aggregation
group contains
member ports on
any of these OAP
modules.
•
You cannot assign a port to a Layer 2 aggregation group if any of the following features are
configured on the port:
MAC authentication (see Security Configuration Guide).
Port security (see Security Configuration Guide).
802.1X (see Security Configuration Guide).
Association between AC and cross connection (see MPLS Configuration Guide).
•
LSQ1FWBSC0
•
LSQ1LBSC0
•
LSQ1NSMSC0
•
LSQ2FWBSC0
•
LSU1FWCEA0
•
LSU3FWCEA0
•
LSU3WCMD0
28
Maximum number
of aggregation
groups
128
1024
Maximum number
of Selected ports in
an aggregation
group
8
32